Dallas–Fort Worth
Gas Line Repair in Dallas–Fort Worth
Smelling gas this minute? Quit reading and walk out of the house. Once you're well clear of it, call the gas utility or 911. With the gas off and the house safe, finding the leak and fixing the pipe is plumbing work.
- Price given before work starts
- Nothing starts until you approve it
- Repair tested before the plumber leaves

The plain facts
Gas piping isn't complicated, but it is unforgiving. The utility owns the line up to the meter. Everything after the meter belongs to the house: the buried run across the yard, the pipe through the attic or under the floor, and the shut-off and connector at each appliance. When the utility finds a leak on the house side, off goes the gas, and off it stays until the piping is repaired and proven tight.
Proving it means a pressure test. The system is capped, pumped up with air and watched on a gauge. If the needle drops, there's a leak somewhere, and we isolate sections until we find it. A single bad fitting gets taken apart and remade. A buried steel line that has rusted through in one place has usually thinned everywhere, and replacing the run is the repair that holds.
When a gas line wants looking at
- A rotten-egg smell indoors or at the meter (get out first; the call to the gas utility or 911 comes second)
- A hissing sound at a pipe, valve or appliance connector
- Your gas was shut off by the utility, or an appliance got tagged
- A patch of dead grass or dying plants over the buried line
- An aging appliance connector, or a shut-off valve that won't turn
No surprises
How the job goes
Make it safe
Gas stays off at the meter until the leak is found. If the utility hasn't been out yet, that call comes first.
Test the whole system
An air test on a gauge shows whether the piping holds. Isolating sections shows which part doesn't.
Price it, then fix it
The repair, or the new run of pipe, is priced for you ahead of time. Nothing is cut or dug until you approve it.
Test again for the inspector
The finished piping goes back under pressure and has to hold. Where a permit applies, the city inspects it before the utility restores service.
How North Texas figures in
Across most of North Texas the gas utility is Atmos Energy, and the rule after a leak is simple: service stays off until three things have happened. The pipe on your side is fixed, it holds a pressure test, and the city inspector passes it. Older neighborhoods add a wrinkle. Many older homes have the meter at the alley or the curb and a steel line buried across the yard to the house. Decades in wet clay rust that pipe from the outside in, which is why so many gas leaks here turn up underground.
Questions about gas lines
What should I do if I smell gas in the house?
Everybody out, pets included. On the way, touch no light switch, leave the car parked where it is in the garage, and don't make the call until you're standing outside. From out there, phone the gas utility on its emergency number, or phone 911. They shut the gas off and make the house safe. The repair comes after that.
The gas company shut me off and left a tag. Now what?
The tag means the leak is on your side of the meter. Before the utility turns the gas back on and relights your appliances, the piping has to be repaired and has to hold a pressure test. Most cities want their own inspector to pass it as well.
Can a leaking gas line just be patched?
A leaking threaded joint can be taken apart and remade, and a bad valve or connector can be replaced. Pipe that has rusted through is different. A clamp on corroded steel isn't a repair and won't hold a test for long. That run needs new pipe.
